Light bar with reflector technology and built-in position light in a slim design. The combination of Curved and Reflector technology optimises the light distribution and the design looks good on modern vehicles, while the optics of the reflector concentrate light on areas where the vehicle's normal lighting is not sufficient. The light pattern is wide and flat, just like the road, thus minimizing light loss up in the air and down into the nearby road surface, which in wet asphalt can otherwise give dazzling reflections. For maximum durability, the lens is made of polycarbonate.

Technical data:
Voltage: 9–30 V
Diodes: 4 x 15 W, 8 x 15 W, 12 x 15 W, 16 x 15 W, 20 x 15 W
Theoretical lumens: 5,400-27,000 lm
Actual lumens: 3 780-20 250 lm
Power consumption: 60-300 W
Dimensions (WxHxD): 317-1293 x 84 x 90 mm 
Cable length: 20 cm deutschkontakt male + 50 cm deutschkontakt female
IP class: 68
Miscellaneous: E-approved according to ECE-R10. EMC-shielded according to EN55015.

Through PWM (Pulse Width Modulation) technology, the LEDs turn on and off at a frequency so high that the eye does not have time to register a flicker. This technology is used both to be able to drive the diodes harder with a lower heat generation and to act as a power-regulating electronic protection when the lamp is at risk of getting too hot. This increases the performance of the lamp and extends its lifespan.